DJB

Conversion Kit For Converting An Accucraft Edrig Loco From Gas Firing To Coal Firing

This is a complete kit with step by step instructions, photos and drawings.

Orders now being taken.

Edrig coal firing conversion

This shows a typical Edrig conversion, parts in the kit may not look identical to the parts shown

Kit contains:-

  • New boiler with, Regulator, Safety valve, Water Gauge and Pump feed Clack Valve, with provision for fitting a Resonator Whistle, uses the Pressure gauge off the original engine.
  • Crosshead driven pump with by-pass valve and Quick fill connector.
  • Stainless grate and Ashpan.
  • Original Lubricator is used.
  • All pipework to connect :- Lubricator, Blower and Main Steam Pipe.
  • Supplied with new cast smokebox with working door.
  • Boiler Cladding Sheet in brass with ceramic insulation.
  • Etched inner side tanks to hold water for the pump.

Kit Price £1,250, carriage extra at cost.

Edrig coal firing conversion

Edrig coal firing conversion

New smokebox fitted to Edrig (and Ragleth). (Please note rosco lubricators not included but can be purchased separately from our range of cosmetic castings).

Contact: Paul Bailey, details below.

Return to top